Polledri Back Spotfacing System Group 6
QUANTITY
With a range from diameter 12 to diameter 125, backspotfacing cutters are manufactured to be fixed to the wide range of pilot arbors diameters through a quick change bayonet which allows, in a short time to fix and remove the citter from the arbor in a way that it’s possible to change quickly from one hole to another one.
ARBORS FOR BACK SPOTFACING CUTTER GR.6 from Ø 6 to Ø 10
The arbors specially devised for our back-spotfacing cutters, have a threaded hole at the end of the taper to allow the locking of the arbor to the machine by means of a drawbar. Alternatively, they can be used with the tang end and locked to the machine with the positioning slot if available. M.T. 1 with no locking slot.
ARBORS in carburized and hardened steel 60 HRC
- GROUP 6
- RANGE: from Ø 6 to Ø 10
- CODE: 60.04
- (EX. Ø 6: 60.04.060)
Back Spotfacing cutters in HSS HRC 63 From Ø 12 to Ø 26.
You can fit them on all the Polledri arbors of the same group. You can connect them on the arbors quickly because they have an special quick change bayonet system. Using a good soluble oil you can increase the speed with an increase of the tool life.
BACK SPOTFACING CUTTERS, 3 FLUTES HSS 63 HRC
- GROUP 6
- RANGE: from Ø 12 to Ø 26
- CODE: 60.01
- (Ex. Ø 12: 60.01.120)
BACK SPOTFACING CUTTER in HARD METAL ISO K 30 from Ø 12 to Ø 22
You can fit them on all the Polledri arbors of the same group. You can connect them on the arbors quickly because they have an special quick change bayonet system. Using a good soluble oil you can increase the speed with an increase of the tool life.
BACK SPOTFACING CUTTER, 3 FLUTES HARD METAL ISO K30
- GROUP 6
- RANGE: From Ø 12 to Ø 22
- CODE: 60.02
- (EX. Ø 12: 60.02.120)
Pen M.6 for stems CM1